840 glazed tile press may need to produce a variety of different looks roof according to production and yield. To check whether the connection is solid throughout, mounting bolts, tighten the nut if, within about chassis lubrication should add a little oil to power-up test machine, first empty running carefully observed, with or without vibration, noise, oil window is to oil, each Are parts of motor coordination, in order to install the mold after everything is normal, when you install the mold, you must cut off the power of the motor by hand moving belt or large gear, so the table indexing, and rose to the highest point of the carriage, the best tile press with the support of an object between the table and the bottom surface of the slide to slip seat naturally fall, causing the accident. Mold 840 glazed tile press need to use a lower and upper die six identical size specifications, install the upper die and a lower die, the die is mounted directly in the six-party table runner, mold mounted on slide a bottom surface, and place the appropriate plate thickness to ensure the upper and lower mold after mold, tile press four evenly around the gap between the upper and lower mold distance equal to the thickness of the tiles you want. Then prevail over mold, table indexing, install the remaining five pay lower die, all in order to drive up and down mode after installing pressure-watts. Technical parameters length × width × height 6400mm × 1300mm × 950mm molding axis: Diameter 70mm 45 # quenched forming wheel: Material 45 # forged chrome plated Transmission: sprockets, chain motor: 3KW Forming Rows: 11 rows of automatic Computer and Cutting System: Pumping Motor: 3KW four Cut Die: Gr12 Forming speed: 8-10m / min suppress thickness: 0.2-0.7mm Width repression: 1000m